Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. Forward bottom frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross-section stability of a forward suspension bracket
   9.8. Bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross-section stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Bottom lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of a steering
   9.21. Air removal from steering system with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Corners of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions





9.8. Bottom lever of a forward suspension bracket

GENERAL INFORMATION

Bottom lever of a forward suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove a forward wheel.
2. Unscrew tightening a bolt, fixing a pin of the spherical hinge of the bottom lever of a forward suspension bracket to a rotary fist.
3. Using the corresponding lever, move the bottom lever of a forward suspension bracket down and separate it from a rotary fist. If the pin of the spherical hinge densely sits in a rotary fist, use a screw-driver or a chisel as a wedge and expand a clip of a rotary fist.
4. Unscrew bolts of fastening of the lever to the bottom frame and remove the lever.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal, and a tightening of sharnirny bolts of fastening of the lever to the bottom frame make after car installation on wheels.