Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. Forward bottom frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross-section stability of a forward suspension bracket
   9.8. Bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross-section stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Bottom lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of a steering
   9.21. Air removal from steering system with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Corners of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

9.7. Stabilizer of cross-section stability of a forward suspension bracket

GENERAL INFORMATION

Forward stabilizer of cross-section stability

Removal

PERFORMANCE ORDER

1. Remove a forward bottom frame.
	2. Unscrew nuts of fastening of drafts of the stabilizer of cross-section stability to a forward rack and remove drafts.
3. Unscrew bolts of fastening of the clips, fixing the stabilizer of cross-section stability to the bottom frame.
4. Remove the stabilizer of cross-section stability from the bottom frame.
5. Note an arrangement and remove rubber plugs from the stabilizer.
6. Check the stabilizer on wear and mechanical damages. Special attention give to a condition of plugs of installation of the stabilizer.

Installation

Installation is made in sequence, return to removal.