Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. Forward bottom frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross-section stability of a forward suspension bracket
   9.8. Bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross-section stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Bottom lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of a steering
   9.21. Air removal from steering system with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Corners of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

9.4. Replacement of forward bearings of a nave

PERFORMANCE ORDER

1. Remove a rotary fist.

2. For nave removal from a rotary fist use a press and a tubular opravka of the corresponding diameter.

3. Establish a rotary fist inside up and, using a metal opravka, choose a nave from nave bearings.

4. Using a stripper, remove an internal ring of the bearing from a nave.

5. Remove a lock ring of fastening of the bearing from the interior of a rotary fist.

6. If necessary establish an internal ring of the bearing back and, opiry an internal part of a rotary fist on supports and using a tubular opravka, squeeze out the bearing from a rotary fist.

7. Clear a nave and a rotary fist of dirt, and greasings.

8. Reliably fix a rotary fist on supports and establish on it the bearing. Installation of the bearing make with use of a tubular opravka which should press on an external ring of the bearing.

9. Fix the bearing a new lock ring which should be established in flutes in a rotary fist.

10. Press a nave in the bearing. Thus use a tubular opravka which presses on an internal ring of the bearing.

11. Establish a rotary fist together with a nave on the car.