Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. Forward bottom frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross-section stability of a forward suspension bracket
   9.8. Bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross-section stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Bottom lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of a steering
   9.21. Air removal from steering system with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Corners of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


5645d6d1

9.22. Tip of steering draft

GENERAL INFORMATION

Removal by a wire brush of a rust and dirt from a tip of steering draft

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports. Remove the corresponding wheel.
2. Fix steering draft and unscrew a lock-nut of steering draft on a turn quarter. Do not move a lock-nut from this situation as it will serve as a reference point at installation of a new tip of steering draft.
3. Unscrew a nut of fastening of the spherical hinge of a tip of steering draft.
4. Using a stripper, take the spherical hinge of a tip of steering draft from a rotary fist.
5. Unscrew a tip of steering draft from steering draft, having counted exact number of turns of a tip of steering draft. The right tip the helmsman of draft is designated by a letter R and has the right carving, and the left tip is designated by a letter L and has the left carving.

Installation

PERFORMANCE ORDER
1. Screw up a tip of steering draft in steering draft on the same number of turns, as at removal. Thus the lock-nut of a tip of steering draft should be established on a quarter of a turn of steering draft.
2. Establish the spherical hinge of a tip of steering draft in a rotary fist and fix a nut.
3. Tighten a lock-nut of fastening of a tip of steering draft.
4. Establish a wheel and lower the car.
5. Check corners of installation of forward wheels.