Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   - 3.1. Repair of the SOCH engine established in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. Top dead point (VMT) of the piston of the first cylinder
      3.1.5. Cover of a head of the block of cylinders
      3.1.6. Pulley of a cranked shaft
      3.1.7. Casings of a gear belt
      3.1.8. Gear belt
      3.1.9. Mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. Cam-shaft and cam-shaft cases
      3.1.12. Hydraulic pushers
      3.1.13. Head of the block of cylinders
      3.1.14. Oil pallet
      3.1.15. Oil pump
      3.1.16. Drive flywheel / plate
      3.1.17. Replacement of sealing rings of a cranked shaft
      3.1.18. Suspension bracket of the power unit
   + 3.2. Repair of the DOCH engine established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major maintenance of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

3.1.5. Cover of a head of the block of cylinders

Removal

PERFORMANCE ORDER

	1. Weaken collars and disconnect a big hose of ventilation of a case from a cover of a head of the block of cylinders
	2. Remove a small hose of ventilation of a case of the engine.
	3. Unscrew bolts of fastening and uncover heads of the block of cylinders.

Installation

PERFORMANCE ORDER

1. Clear an internal surface of a head of the block of cylinders of oil deposits. Check a condition of the filter of an oil separator in a cover and if it is polluted, unscrew bolts, remove it and wash out.
	2. Check, that sealing laying (arrow) settled down in cover grooves, and establish a cover on the engine.
	3. Fix a cover bolts, having tightened them the demanded moment, and a tightening carry out in diagonal sequence. At installation of bolts establish under them brackets of fastening of high-voltage wires (arrow).
4. Connect hoses of ventilation of a case.