Opel Vectra B
since 1995 of release
Repair and car operation
Vektr B. Opel
+
1.1. Governing bodies and control devices
+
2. Maintenance
-
3. Engines
-
3.1. Repair of the SOCH engine established in the car
3.1.1. Introduction
3.1.2. Technical characteristics
3.1.3. Check of pressure of compression
3.1.4. Top dead point (VMT) of the piston of the first cylinder
3.1.5. Cover of a head of the block of cylinders
3.1.6. Pulley of a cranked shaft
3.1.7. Casings of a gear belt
3.1.8. Gear belt
3.1.9. Mechanism of a tension of a gear belt and pulleys
3.1.10. Replacement of a sealing ring of a cam-shaft
3.1.11. Cam-shaft and cam-shaft cases
3.1.12. Hydraulic pushers
3.1.13. Head of the block of cylinders
3.1.14. Oil pallet
3.1.15. Oil pump
3.1.16. Drive flywheel / plate
3.1.17. Replacement of sealing rings of a cranked shaft
3.1.18. Suspension bracket of the power unit
+
3.2. Repair of the DOCH engine established in the car
+
3.3. Repair of the diesel engine of 1,7 l established in the car
+
3.4. Repair of the diesel engine of 2,0 l established in the car
+
3.5. Major maintenance of engines
+
4. Heating, ventilation
+
5. Fuel system
+
6. Systems of start, ignition
+
7. Transmission
+
8. Brake system
+
9. Running gear
+
10. Body
+
11. Electric equipment
+
12. Main malfunctions
3.1.12. Hydraulic pushers
Removal
PERFORMANCE ORDER
1.
Remove the camshaft case.
2.
Remove levers of a block of axial pressure.
3.
Remove a block of axial pressure.
4.
Remove hydraulic pushers and place everything in the corresponding container so that at installation they became everyone on the place.
Check
PERFORMANCE ORDER
1.
Check working surfaces of the bearing, a pusher, the valve which work in contact to camshaft cams.
2.
If defective, them it is necessary to replace hydraulic pushers, as their check is impossible.
Installation
PERFORMANCE ORDER
1.
Grease hydraulic pushers and nests in a head of the block of cylinders with pure engine oil. Establish hydraulic pushers on the places.
2.
Establish blocks of axial pressure upon the top parts of the corresponding valves.
3.
Grease levers with pure engine oil and establish them on the places. Then establish the camshaft case.