Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   - 5.1. Fuel system of petrol engines
      5.1.1. Introduction
      5.1.2. Technical characteristics
      5.1.3. Air filter and inlet channels
      5.1.4. A control system in temperature of air submitted to the engine
      5.1.5. Accelerator cable
      5.1.6. Accelerator pedal
      5.1.7. Fuel
      + 5.1.8. System of injection of fuel
      5.1.9. Pressure removal in fuel system
      5.1.10. Fuel pump
      5.1.11. Fuel level sensor
      5.1.12. Fuel tank
      5.1.13. Throttle case
      5.1.14. Check of system of injection of fuel
      5.1.15. Elements of one-dot system of injection of fuel
      + 5.1.16. Elements of multipoint system of injection of fuel
      5.1.17. Inlet collector
      5.1.18. Final collector
      5.1.19. System of production of exhaust gases
   + 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

5.1.9. Pressure removal in fuel system

GENERAL INFORMATION

Prevention

At work on fuel system it is necessary to remove previously pressure in system.

SOCH engines of 1,6 l

PERFORMANCE ORDER

1. Switch off ignition.
	2. Uncover the relay block.
	3. Take the relay of the fuel pump (the relay of violet color).
4. Start the engine in an idling mode to an engine stop.
5. Remove a weight wire from the accumulator and establish the relay in the block of the relay and close a cover of the block of the relay.

L DOCH 1.6, 1.8 and 2 engines

On these engines pressure in fuel system can be removed by a method described above, or as follows.

PERFORMANCE ORDER

1. Unscrew a stopper from the valve of removal of pressure and establish the corresponding container under the valve.

2. On engines of 1,6 l the valve is located at an end face of the fuel highway (it is specified by an arrow).

3. On l engines 1,8 and 2,0 the valve is located from above the fuel highway (it is specified by an arrow).

4. A screw-driver press a valve zolotnik, thus it will leave fuel, and remove pressure in fuel system.

5. Screw a stopper on a head of the valve of removal of pressure.