Vektr B. Opel + 1.1. Governing bodies and control devices + 2. Maintenance + 3. Engines + 4. Heating, ventilation - 5. Fuel system - 5.1. Fuel system of petrol engines 5.1.1. Introduction 5.1.2. Technical characteristics 5.1.3. Air filter and inlet channels 5.1.4. A control system in temperature of air submitted to the engine 5.1.5. Accelerator cable 5.1.6. Accelerator pedal 5.1.7. Fuel + 5.1.8. System of injection of fuel 5.1.9. Pressure removal in fuel system 5.1.10. Fuel pump 5.1.11. Fuel level sensor 5.1.12. Fuel tank 5.1.13. Throttle case 5.1.14. Check of system of injection of fuel 5.1.15. Elements of one-dot system of injection of fuel + 5.1.16. Elements of multipoint system of injection of fuel 5.1.17. Inlet collector 5.1.18. Final collector 5.1.19. System of production of exhaust gases + 5.2. Fuel systems of the diesel engine + 6. Systems of start, ignition + 7. Transmission + 8. Brake system + 9. Running gear + 10. Body + 11. Electric equipment + 12. Main malfunctions
|
Removal
PERFORMANCE ORDER |
|
1. In a motor compartment remove a bracket of fastening of a cover of a cable of an accelerator and take an accelerator cable from a throttle cam. |
|
2. Release an accelerator cable on all length from under fastening. On models with an automatic transmission it is necessary to disconnect the electric socket from the mechanism of inclusion of a low gear which is established on an accelerator cable. |
3. In salon of the car unscrew clips and remove the bottom furnish of the panel from the driver for access to a pedal of management of supply of fuel. |
4. Remove a bracket of fastening and disconnect an accelerator cable from the top part of a pedal, management of supply of fuel. |
5. In a motor compartment take from a partition a ring condensing a cable of an accelerator, and take an accelerator cable. |
|
Installation
PERFORMANCE ORDER |
1. From a motor compartment insert an accelerator cable on a place and establish condensing ring of a cable of an accelerator on a partition of a motor compartment. |
2. Establish a cable cover in a clamp of a suspension bracket of a pedal, and a cable of an accelerator connect to a pedal of management of supply of fuel. |
3. In a motor compartment check that the cover of a cable of an accelerator is correctly placed in a condensing ring of a partition, then place a cable on all length in fastening brackets. |
4. Connect an accelerator cable to a cam of a throttle and fix a bracket. Establish a cable cover in an arm and adjust the provision of a cable of an accelerator. |
|
Adjustment
PERFORMANCE ORDER |
|
1. In a motor compartment remove a clip of fastening of a cover of a cable of an accelerator. |
2. Check, that the cam of a throttle was in the starting position and, moving a cable cover, choose sagging of a cable of an accelerator. |
3. In the established provision of a cable establish a fastening clip on external flutes of a cover of a cable before a rubber condensing ring and a washer. After clip and cable installation on the places only insignificant sagging of a cable of an accelerator should be observed. |
4. While the assistant smoothly presses an accelerator pedal, check that the throttle cam completely turns and comes back to a starting position. |
|
|
|