Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   - 5.1. Fuel system of petrol engines
      5.1.1. Introduction
      5.1.2. Technical characteristics
      5.1.3. Air filter and inlet channels
      5.1.4. A control system in temperature of air submitted to the engine
      5.1.5. Accelerator cable
      5.1.6. Accelerator pedal
      5.1.7. Fuel
      + 5.1.8. System of injection of fuel
      5.1.9. Pressure removal in fuel system
      5.1.10. Fuel pump
      5.1.11. Fuel level sensor
      5.1.12. Fuel tank
      5.1.13. Throttle case
      5.1.14. Check of system of injection of fuel
      5.1.15. Elements of one-dot system of injection of fuel
      + 5.1.16. Elements of multipoint system of injection of fuel
      5.1.17. Inlet collector
      5.1.18. Final collector
      5.1.19. System of production of exhaust gases
   + 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

5.1.18. Final collector

Removal and installation

PERFORMANCE ORDER

SOCH engines of 1,6 l

1. Disconnect the electric socket from the oxygen sensor, located on sensor wires. Release sensor electroconducting from fastening brackets so that the sensor could be removed together with a collector.

2. Remove a reception exhaust pipe.

3. Remove a zabornik of warmed-up air from a final collector.

4. Take щуп measurements of level of engine oil and remove high-voltage wires from candles of the 2nd and 3rd cylinders. Unscrew and remove the heat resisting screen of a final collector.

5. Unscrew nuts and remove a final collector from the engine together with laying.

6. Installation is made in sequence, return to removal. Thus it is necessary to use new laying of a final collector.

Other models

7. Remove the secondary pneumovalve of system of supply of air and a connecting branch pipe.

8. On models of 1,6 l disconnect the electric socket of the sensor of the oxygen, located on wires, release electroconducting from fastening brackets so that the sensor could be removed together with a collector.

9. Unscrew bolts of fastening of a reception exhaust pipe to a collector.

10. Unscrew nuts and remove a final collector together with laying.

11. Installation is made in sequence, to removal, thus it is necessary to establish to return new laying of a final collector and a reception exhaust pipe.