Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
+ 7.1. Coupling
+ 7.2. Mechanical transmission
- 7.3. Automatic transmission
7.3.1. Introduction
7.3.2. Technical characteristics
7.3.3. Oil replacement in a transmission
7.3.4. Adjustment of the lever of the selector
7.3.5. Selector cable
7.3.6. Selector lever
7.3.7. Replacement of a sealing ring of the hydrotransformer
7.3.8. Electric elements of management of a transmission
7.3.9. Switch of a manner of movement
7.3.10. Electronic control device
7.3.11. Sensors of an entrance and conducted shaft of a transmission
7.3.12. Sensor of temperature of oil of a transmission
7.3.13. Removal and transmission installation
7.3.14. Major maintenance of a transmission
+ 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions
|
Blokirator of a starter and switch of lamps of a backing
|
|
1. Marking
2. Bolt
3. Shaft of the mechanism of a choice of transfers
4. Bolt |
Blokirator of a starter and switch of a lamp of a backing
Blokirator of a starter and the switch of lamps of a backing includes backing lamps at installation of the mechanism of a choice of transfers to the relevant situation and prevents engine start when any transfer is included.
Removal
| PERFORMANCE ORDER |
| 1. Establish the selector lever in situation N. |
| 2. For access to the switch remove the accumulator and an accumulator support. |
| 3. Remove a selector cable from the lever of a choice of transfers on a transmission. Unscrew a nut and remove the lever from a shaft of the mechanism of a choice of transfers. |
| 4. Disconnect the electric socket of the switch located on wires. |
| 5. On the engine 1,8 and 2,0 of l take щуп for measurement of level of oil in a transmission, unscrew a nut and remove a pipe щупа. |
| 6. Unscrew a nut from a shaft of a choice of transfers. |
| 7. Unscrew a bolt of fastening of a plate of the switch and take the switch from a motor compartment. |
| 8. Installation is made in sequence, return to removal. Thus it is necessary to make switch adjustment. |
|
Adjustment
Prevention
Before adjustment of the switch check that the cable of the selector is correctly adjusted.
| PERFORMANCE ORDER |
| 1. Establish the selector lever in situation N. |
| 2. For access to the switch remove the accumulator and an accumulator support. |
| 3. Remove a selector cable from the lever of a choice of transfers on a transmission. Unscrew a nut and remove the lever from a shaft of the mechanism of a choice of transfers. |
| 4. On a transmission established in neutral situation, washers on a shaft of the mechanism of a choice of transfers should be parallel to marking on the switch case (see fig. Blokirator of a starter and the switch of lamps of a backing). If it is necessary to make adjustment, weaken bolts of fastening of the case of the switch and turn the switch in demanded situation. |
| 5. Establish the lever of a choice of transfers and fix a nut. Connect a selector cable to the lever and fix a bracket. |
| 6. Establish the accumulator and check operation of the switch. |
|
|
|
