Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical transmission
   - 7.3. Automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Oil replacement in a transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. Selector cable
      7.3.6. Selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of management of a transmission
      7.3.9. Switch of a manner of movement
      7.3.10. Electronic control device
      7.3.11. Sensors of an entrance and conducted shaft of a transmission
      7.3.12. Sensor of temperature of oil of a transmission
      7.3.13. Removal and transmission installation
      7.3.14. Major maintenance of a transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


5645d6d1

7.3.11. Sensors of an entrance and conducted shaft of a transmission

GENERAL INFORMATION

Arrangement of sensors of speed of an entrance shaft and conducted shaft

Sensors are located in the top part of a transmission. The sensor of speed of an entrance shaft is located closer by the left forward end of a transmission.
1. Sensor of speed of an entrance shaft
2. The sensor of speed of a conducted shaft

Removal

PERFORMANCE ORDER
1. For access to sensors remove the accumulator and an accumulator support.
2. Disconnect the electric socket from sensors.
3. Unscrew bolts and remove sensors.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal. Thus on sensors it is necessary to establish new sealing rings.