Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical transmission
   - 7.3. Automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Oil replacement in a transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. Selector cable
      7.3.6. Selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of management of a transmission
      7.3.9. Switch of a manner of movement
      7.3.10. Electronic control device
      7.3.11. Sensors of an entrance and conducted shaft of a transmission
      7.3.12. Sensor of temperature of oil of a transmission
      7.3.13. Removal and transmission installation
      7.3.14. Major maintenance of a transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


7.3.5. Selector cable

Removal and installation

1. Remove the central console and establish the selector lever in situation P.
2. Using an edge of a thin screw-driver (it is specified by an arrow) as the lever, remove a selector (2) cable from spherical sharnirny connection (3) at the basis of the lever of the selector. Release a selector cable from a forward part of an arm of the lever of the selector.
1–fastening bracket.
3. Remove the accumulator and an accumulator support.
4. Remove a selector cable from the lever of a choice of transfers on a transmission. Remove from an arm a cover of a cable of the selector.
5. Disconnect a selector cable from all brackets of fastening. Take a sealing ring of a cable of the selector from a partition of a motor compartment and take a selector cable.
6. Installation is made in sequence, return to removal, thus it is necessary to adjust a selector cable.