Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine established in the car
   + 3.2. Repair of the DOCH engine established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   - 3.4. Repair of the diesel engine of 2,0 l established in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. Top dead point (VMT) of the piston of the first cylinder
      3.4.5. Check and adjustment of the mechanism of a gazoraspredeleniye
      3.4.6. Cover of a head of the block of cylinders
      3.4.7. Pulley of a cranked shaft
      3.4.8. Chain cover
      3.4.9. Natyazhiteli of a chain
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. Head of the block of cylinders
      3.4.13. Oil pallet
      3.4.14. Oil pump
      3.4.15. Oil radiator
      3.4.16. Replacement of sealing rings of a cranked shaft
      3.4.17. Flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Major maintenance of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


5645d6d1

3.4.13. Oil pallet

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Lift a forward part of the car and fix on supports.
3. Merge engine oil. Establish a new washer on a masloslivny stopper and establish a stopper in the oil pallet, having tightened it the demanded moment.
4. Disconnect electric sockets from sensors of temperature and oil level.
5. Unscrew bolts of fastening of a ledge of the oil pallet to a transmission case.
6. Gradually and consistently unscrew bolts of fastening of the oil pallet to the block of cylinders. Remove the oil pallet and laying.
7. Unscrew bolts of fastening of a pipe of a maslopriyemnik and check a condition of the mesh filter.

Installation

PERFORMANCE ORDER
1. Clear all traces of oil and dirt from interfaced surfaces of the pallet and the block of cylinders.
2. Establish a new sealing ring on a pipe of a maslopriyemnik and establish a pipe into place.
3. Apply a thin film hermetic on the bottom surface of the block of cylinders interfaced to the oil pump and a back main cover of the bearing (places of drawing of hermetic are specified by shooters).
4. Establish laying on the oil pallet and establish laying on the block of cylinders. Fix the oil pallet bolts.
5. Working from the center in diagonal sequence, tighten bolts of fastening of the oil pallet.
6. Screw up bolts of fastening of a ledge of the oil pallet to a transmission case.
7. Connect electric sockets to sensors of temperature and oil level.
8. Lower the car and fill in engine oil in the engine.