Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
+ 3.1. Repair of the SOCH engine established in the car
- 3.2. Repair of the DOCH engine established in the car
3.2.1. Introduction
3.2.2. Technical characteristics
3.2.3. Compression check
3.2.4. Top dead point (VMT) of the piston of the first cylinder
3.2.5. Cover of a head of the block of cylinders
3.2.6. Pulley of a cranked shaft
3.2.7. Casings of a gear belt
3.2.8. Gear belt
3.2.9. Pulleys of a gear belt, mechanism of a tension and single pulley
3.2.10. Replacement of oil sealing rings of a cam-shaft
3.2.11. Cam-shaft and pushers
3.2.12. Head of the block of cylinders
3.2.13. Oil pallet
3.2.14. Oil pump
3.2.15. Drive flywheel / plate
3.2.16. Replacement of oil sealing rings of a cranked shaft
3.2.17. Suspension bracket of the power unit
+ 3.3. Repair of the diesel engine of 1,7 l established in the car
+ 3.4. Repair of the diesel engine of 2,0 l established in the car
+ 3.5. Major maintenance of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions
|
Removal
| PERFORMANCE ORDER |
Prevention
For fastening of a pulley it is necessary to use a new bolt.
|
| 1. Lift a forward part of the car and fix on supports. Remove the right wheel. |
| 2. Remove an auxiliary driving belt. |
| 3. Weaken a bolt of fastening of a pulley of a cranked shaft. For prevention of a provorachivaniye of a cranked shaft it is necessary, that the assistant included any transfer and pressed a brake. On models with an automatic transmission unscrew one of bolts of fastening of the hydrotransformer and, using the steel core inserted through an opening under a bolt, block a drive plate. |
| Engines of 1,6 l |
| 4. Unscrew a bolt of fastening of a pulley and remove a pulley from a cranked shaft. |
| L engines 1,8 and 2,0 |
| 5. For a bolt of fastening of a pulley of a cranked shaft turn a cranked shaft until the label on a pulley will not be combined with the index on a cover. |
| 6. Unscrew bolts of fastening of an auxiliary pulley to a pulley of a gear belt and remove a pulley. |
|
Installation
| PERFORMANCE ORDER |
| Engines of 1,6 l |
| 1. Establish a pulley of a cranked shaft. Thus combine a groove on a pulley with a ledge on a pulley of a gear belt. |
| 2. Fix a pulley a bolt. Thus fix a cranked shaft from a provorachivaniye. |
| 3. Establish an auxiliary driving belt. |
| 4. Establish a wheel and lower the car. |
| L engines 1,8 and 2,0 |
| 5. Check that the label of a pulley of a cranked shaft is combined with a label on the case, and establish a pulley of an auxiliary maple belt on a cranked shaft. Combine a label on a pulley with the index and fix a pulley bolts. |
| 6. Establish an auxiliary driving belt. |
| 7. Establish a wheel and lower the car. |
|
|
|
