Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine established in the car
   - 3.2. Repair of the DOCH engine established in the car
      3.2.1. Introduction
      3.2.2. Technical characteristics
      3.2.3. Compression check
      3.2.4. Top dead point (VMT) of the piston of the first cylinder
      3.2.5. Cover of a head of the block of cylinders
      3.2.6. Pulley of a cranked shaft
      3.2.7. Casings of a gear belt
      3.2.8. Gear belt
      3.2.9. Pulleys of a gear belt, mechanism of a tension and single pulley
      3.2.10. Replacement of oil sealing rings of a cam-shaft
      3.2.11. Cam-shaft and pushers
      3.2.12. Head of the block of cylinders
      3.2.13. Oil pallet
      3.2.14. Oil pump
      3.2.15. Drive flywheel / plate
      3.2.16. Replacement of oil sealing rings of a cranked shaft
      3.2.17. Suspension bracket of the power unit
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major maintenance of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

гг покерок код

3.2.16. Replacement of oil sealing rings of a cranked shaft

PERFORMANCE ORDER

Right sealing ring
1. Remove a pulley of a cranked shaft.
	2. Drill in a sealing ring two small openings, located in the opposite ends of consolidation. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, take for heads of screws a sealing ring.
3. Clear a nest of a sealing ring.
	4. Grease working edges of a new sealing ring with fresh engine oil and, using a tubular opravka, establish a sealing ring in a nest.
5. Clear all traces of oil, then establish a pulley of a cranked shaft.
Left oil sealing ring
6. Remove a flywheel or a drive plate.
7. Drill in a sealing ring two small openings, located in the opposite ends of consolidation. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, take out for heads of screws a sealing ring.
8. Clear a nest of a sealing ring.
9. Grease working edges of a new sealing ring with fresh engine oil and, using a tubular opravka, establish a sealing ring in a nest.
10. Establish a flywheel or a drive plate.