Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
- 1.1. Governing bodies and control devices
   1.2. Combination of devices
   1.3. Control bulbs
   1.4. Counter of the passable way and hours
   1.5. Triple-Info-display
   1.6. Multi-Info-display
   1.7. The Multi-Info-display - Check-control
   1.8. The Multi-Info-display - the Board computer
   1.9. Heating and ventilation system
   1.10. Conditioner
   1.11. Heating
   1.12. Electronic climate control
   1.13. TC system
   1.14. Cruise control
   1.15. Catalyst
   1.16. Signaling device of electronic system of the engine
   1.17. System of production of the fulfilled gases
   1.18. Automatic transmission
   1.19. Instructions on driving
   1.20. Economy of fuel
   1.21. Fuel grade
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


5645d6d1

1.5. Triple-Info-display

GENERAL INFORMATION

Indication of time, external temperature, and also radio receiver or date.

At the included ignition time and external temperature are displayed, at the switched-off radio receiver date is displayed.
Brightness of indication is regulated at the included lighting by means of the right regulator located under the switch of lighting.
At the switched-off ignition about 15 seconds indication of time, date and external temperature by short pressing of one of two buttons from above the display can be caused short-term.

Date and time installation

 

To switch off a radio receiver, and buttons over the display to press in the following order:

Installation mode:

about 2 seconds, days blink;
to establish day;
months blink;
to establish month;
years blink;
to establish year;
hours blink;
to establish hours;
minutes blink;
to establish minutes;
hours to within a second join.

If installation only is required to time, in a mode of installation to press the button until hours or minutes will start to blink.

Automatic installation of date and time

Automatic installation of date and time is possible during reception of broadcasts from radio stations with RDS of RDS radiating a signal.
Automatic installation is carried out after inclusion of a radio receiver and reception of a signal of RDS. Process of installation is displayed on the display by means. If there is no reception of a signal of RDS or it poor-quality, it is necessary to establish date and time manually.
Switching off and inclusion of automatic installation (e.g. during poor-quality reception of a signal of RDS from radio station):

to hold pressed about 2 seconds, hours are transferred to an installation mode;
to press two times (years will not start blinking yet);
to hold pressed about 3 seconds, will not start blinking yet on the display and not to appear „RDS TIME" inscription (during it years blink);
to press, indication on the display:
RDS TIME 0 = off,
RDS TIME 1 = incl.;
to press three times.

External temperature

The going-down temperature is displayed immediately, raising – with a delay.
For the prevention of a road icing indication at temperature below 3 °C on the display is deduced a symbol.