Opel Vectra B

since 1995 of release

Repair and car operation


Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   - 7.2. Mechanical transmission
      7.2.2. Introduction
      7.2.2. Technical characteristics
      7.2.3. Oil replacement in a transmission
      7.2.4. Adjustment of the mechanism of gear shifting
      7.2.5. Gear shifting mechanism
      7.2.6. Replacement of sealing rings
      7.2.7. Switch of a lamp of a backing
      7.2.8. Transmission removal
   + 7.3. Automatic transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


5645d6d1

7.2.5. Gear shifting mechanism
GENERAL INFORMATION

Mechanism of a choice of transfers

 The mechanism of gear shifting consists of the lever of gear shifting, a rod and the mechanism of a choice of transfers.

Removal

PERFORMANCE ORDER
Lever and gear shifting rod
1. Lift a forward part of the car and fix on supports. Remove an engine mudguard.
2. Using paint or a marker, put combination labels on a rod of gear shifting and a clip on a forward part of draft. Weaken tightening a bolt (it is specified by an arrow), having unscrewed it on two turns.
3. Move the gear shifting lever to the provision of the 4th transfer, release a gear shifting rod from a clip and take from a rubber protective cover.
4. Remove the central console.
5. Unscrew screws and remove furnish of the lever of gear shifting together with switches and disconnect from them electric sockets.
6. Unscrew 4 bolts of fastening of the lever of gear shifting to a floor and take the gear shifting lever together with a rod from the car.
Mechanism of a choice of transfers
7. Separate a gear shifting rod from a clip of the mechanism of a choice of transfers. Tightening the bolt is located in a back part of a transmission before a partition of a motor compartment.
8. Press a clamp (it is specified by an arrow a photo at the left) and remove the sharnirny finger connecting draft to the lever of the selector on the top part of a transmission (a photo on the right).
9. Remove a lock ring and take the mechanism of a choice of transfers up.

Installation
PERFORMANCE ORDER
Lever of gear shifting and rod
1. Grease all hinges of the lever of gear shifting, establish the lever on a place and fix bolts.
2. Connect electric sockets to switches of furnish of the lever and establish lever furnish into place.
3. Under the car establish a rubber protective cover on a gear shifting rod.
4. Attach a gear shifting rod with a draft clip. Combine the labels put before removal, and tighten tightening a bolt.
5. Check operation of the mechanism of gear shifting and, if necessary, adjust.
Mechanism of a choice of transfers
6. Grease sharnirny connections of the mechanism of a choice of transfers
7. Establish the mechanism of a choice of transfers and fix a lock ring.
8. Combine draft with the lever of the selector of transfers and fix a new sharnirny finger.
9. Connect a gear shifting rod to a draft clip. Combine the labels put before removal, and tighten tightening a bolt.
10. Check operation of the mechanism of gear shifting and, if necessary, adjust.