Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
+ 1.1. Governing bodies and control devices
- 2. Maintenance
   + 2.1. Weekly checks
   + 2.2. Maintenance of petrol engines
   - 2.3. Maintenance of diesel engines
      2.3.1. Introduction
      2.3.2. Technical characteristics
      2.3.3. Periodicity of service
      + 2.3.4. Each 75 000 km or 6 months
      - 2.3.5. Each 15 000 km or 12 months
         2.3.5.1. Check and replacement of an auxiliary driving belt
         2.3.5.2. Water removal from the fuel filter
         2.3.5.3. Check and adjustment of turns of idling
         2.3.5.4. Check of forward brake shoes and brake disk
         2.3.5.5. Check of back brake shoes and brake disk
         2.3.5.6. Check of tightness of hoses and liquid effluence
         2.3.5.7. Replacement of the filter of pollen of system of ventilation
      + 2.3.6. Each 30 000 km or 2 years
      + 2.3.7. Each 2 years irrespective of car run
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions





2.3.5.3. Check and adjustment of turns of idling

PERFORMANCE ORDER
Engines of 1,7 l
1. Check that the cable of an accelerator is correctly adjusted.
2. Warm up the engine to working temperature and check idling turns.
3. For adjustment of turns of idling weaken a lock-nut (1) and rotate the screw of adjustment of turns of idling (2). After achievement by the engine of demanded turns of idling tighten a lock-nut.
Engines of 2,0 l
4. Check should be made annually on the car with intensive operation and once in three years on the car with a usual mode of operation. Check of a control system by the engine is made by inclusion of a special electronic tester in the diagnostic socket of system to check record in memory of damages of the electronic control device.
5. If the engine works normally, and the control lamp of the alarm system of engine management in a combination of devices works in a usual mode, it is not required to make control.