Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical transmission
   - 7.3. Automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Oil replacement in a transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. Selector cable
      7.3.6. Selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of management of a transmission
      7.3.9. Switch of a manner of movement
      7.3.10. Electronic control device
      7.3.11. Sensors of an entrance and conducted shaft of a transmission
      7.3.12. Sensor of temperature of oil of a transmission
      7.3.13. Removal and transmission installation
      7.3.14. Major maintenance of a transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

7.3.3. Oil replacement in a transmission

PERFORMANCE ORDER

1. Make a short trip for transmission finishing to working temperature.
2. Establish the car on the lift or over a viewing hole.
	3. Take the index of level of oil, then establish the corresponding container under a drain stopper of a transmission. The drain stopper (1) is located from the back right side of a case of a transmission.
4. Unscrew a drain stopper and merge oil from a transmission.
5. Establish a sealing washer on a stopper and screw up a stopper into place.
6. Fill in oil in a transmission through a pipe of a measuring instrument of level of oil.
7. Start the engine in an idling mode for some minutes, switch off the engine and check oil level in a transmission. If necessary add oil. Make control check and repeatedly check oil level.