Opel Vectra B

since 1995 of release

Repair and car operation



Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   - 7.1. Coupling
      7.1.1. Introduction
      7.1.2. Technical characteristics
      7.1.3. Air removal from hydraulic system of coupling
      7.1.4. Main cylinder
      7.1.5. Working cylinder of coupling
      7.1.6. Coupling pedal
      7.1.7. Leading knot of coupling
   + 7.2. Mechanical transmission
   + 7.3. Automatic transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


5645d6d1

7.1.4. Main cylinder

Removal

PERFORMANCE ORDER
1. For improvement of access to the main cylinder of coupling remove the relay block from the top part of the ABS modulator and move it aside. If necessary remove the vacuum amplifier of brakes.
2. To reduce loss of brake liquid, uncover a nutritious tank, enclose a leaf of polyethylene and reliably screw up a cover on a tank.
3. Weaken a collar and remove a pipe of the main cylinder of coupling from a nutritious tank, close a pipe and the union of a nutritious tank jams.
4. In salon of the car unscrew clips and remove furnish of the lower part of the dashboard from the driver for access to a coupling pedal.
5. Release a bracket of fastening and remove a hydraulic hose of the working cylinder of coupling from a working part of the main cylinder. Close a pipe and the channel of the main cylinder of coupling by jams.
6. In salon of the car remove a bracket and take a pin, a fixing pusher of the main cylinder to a coupling pedal.
7. In a motor compartment unscrew nuts and remove the main cylinder of coupling.

Installation

PERFORMANCE ORDER
1. Check that an interfaced surface of the main cylinder of coupling and a partition of a motor compartment, pure and dry and establish laying.
2. Establish the main cylinder of coupling so that the collar of a pusher was correctly combined with a coupling pedal. Put the clamps fastenings of the main cylinder of coupling.
3. Grease a pin with universal greasing, combine a collar of a pusher and a pedal of coupling and establish a pin. Fix a pin a lock bracket.
4. Connect a hose of the working cylinder of coupling to the main cylinder and fix it a fastening bracket.
5. Establish furnish of the lower part of the dashboard from the driver.
6. Connect a hose of the main cylinder to a nutritious tank and fix a collar.
7. Remove air from hydraulic system of coupling.