Opel Vectra B

since 1995 of release

Repair and car operation

Vektr B. Opel
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine established in the car
   + 3.2. Repair of the DOCH engine established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   - 3.4. Repair of the diesel engine of 2,0 l established in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. Top dead point (VMT) of the piston of the first cylinder
      3.4.5. Check and adjustment of the mechanism of a gazoraspredeleniye
      3.4.6. Cover of a head of the block of cylinders
      3.4.7. Pulley of a cranked shaft
      3.4.8. Chain cover
      3.4.9. Natyazhiteli of a chain
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. Head of the block of cylinders
      3.4.13. Oil pallet
      3.4.14. Oil pump
      3.4.15. Oil radiator
      3.4.16. Replacement of sealing rings of a cranked shaft
      3.4.17. Flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Major maintenance of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

3.4.16. Replacement of sealing rings of a cranked shaft

PERFORMANCE ORDER

Right sealing ring of a cranked shaft
1. Remove a pulley of a cranked shaft.
	2. Using a screw-driver edge as the lever, take a sealing ring from a chain cover.
3. Clear a nest of a sealing ring and a condensed surface of a cranked shaft.
	4. Grease working edges of a new sealing ring with pure engine oil and, using a tubular opravka, establish a sealing ring.
5. Remove all traces of oil and establish a pulley of a cranked shaft.
Left sealing ring of a cranked shaft
6. Remove a flywheel.
	7. Drill two small openings in an end face of a sealing ring, screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest.
8. Clear a nest of a sealing ring and a condensed surface of a cranked shaft.
	9. Grease working edges of a new sealing ring with pure engine oil and, using a tubular opravka, establish a sealing ring into place.
10. Establish a flywheel.